SLIDE 1 PVMD
Delft University of Technology
Illuminated JV – Setup and Measurement
René van Swaaij
SLIDE 2 Learning objectives
SLIDE 3 Learning objectives
- Typical JV testing setup
- Measurement procedure
SLIDE 4
Measurement Setup
Voltage supply Sourcemeter 25 °C Temperature probe Water cooling system Light source(s) Shutter Stage Solar cell
SLIDE 5
Measurement Setup
Voltage supply Sourcemeter 25 °C Temperature probe Water cooling system Light source(s) Shutter Stage Solar cell
SLIDE 6
Lamp spectra
Xe lamp
SLIDE 7
Filtered Xe lamp
Lamp spectra
SLIDE 8
Ha lamp
Lamp spectra
SLIDE 9
Lamp spectra
Filtered IR
Ha lamp
SLIDE 10 19 LED’s
Lamp spectra
Spectrum: Aescusoft LEDSim
SLIDE 11
Measurement Setup
Voltage supply Sourcemeter 25 °C Temperature probe Water cooling system Light source(s) Shutter Stage Solar cell
SLIDE 12
Measurement Setup
Voltage supply Sourcemeter 25 °C Temperature probe Water cooling system Light source(s) Shutter Stage Solar cell
SLIDE 13
2 Point probe
V A
SLIDE 14
2 Point probe
V A
D = 15.5 cm D
SLIDE 15
2 Point probe
V A
D = 15.5 cm D
𝐽 = 40 &'
(&)
* · 𝐸- cm- = 9.6A
SLIDE 16
4 Point probe
V A
SLIDE 17 Reference cell
Source figure: Fraunhofer 2017
SLIDE 18 Reference cell
Source figure: Fraunhofer 2017
Wavelength [nm] Spectral Response [mA/W/m2]
SLIDE 19
Video performing a measurement
SLIDE 20 Summary
- Solar simulator spectrum obtained by combining different
types of light sources
SLIDE 21 Summary
- Solar simulator spectrum obtained by combining different
types of light sources
- Accurate JV measurement by the 4-point probe method
SLIDE 22 Summary
- Solar simulator spectrum obtained by combining different
types of light sources
- Accurate JV measurement by the 4-point probe method
- Reference cells required to control the solar simulator’s
spectral intensity