#prep X Carriage JellyBox Build: 05_X Carriage 1.02min In this - - PDF document

▶

May 15, 2023 10 likes •42 views

#prep X Carriage JellyBox Build: 05_X Carriage 1.02min In this video, we build the X-carriage. _________________________________________________________________ Title: You'll Need X carriage Quick release clamp Quick release knob M4 oversize

SLIDE 1

JellyBox Build: 05_X Carriage 1.02min In this video, we build the X-carriage. _________________________________________________________________

Title: You'll Need

X carriage Quick release clamp Quick release knob M4 oversize washer M4x25 hex head bolt Any hex key

#prep X Carriage

Page 1

SLIDE 2

Any hex key

Page 2

SLIDE 3

Drive the bolt through the hexagonal hole inside the carriage in upwards direction. Slide the quick release clamp over the bolt. Put the M4 oversize washer onto the bolt. Finger-tighten in place with the M4 knob. Pro Tip: Use a hex key to hold the bolt in place.

Page 3