Engineering Design (8023810-2) Dr. Mouaaz Nahas Final Presentation - - PowerPoint PPT Presentation

Engineering Design (8023810-2)

• Dr. Mouaaz Nahas

Final Presentation Template #: Slide:

• No. of

Slides: Contents:

• 1. Title

1 Title Course Name & Course Number (e.g. Engineering Design (8023810-2)) Group Number Team Name & Number Team Members’ Names & ID’s Advisor: Dr Mouaaz Nahas Affiliation: Electrical Engineering Department, College of Engineering and Islamic Architecture, Umm Al-Qura University, Makkah, KSA Semester & Year (e.g. Semester 2, 1439-1440 H)

• 2. Outline

1 The outline or agenda of your presentation (in bullet points).

• 3. Introduction

1 The introduction to your presentation (in bullet points). You should include pictures(s).

• 4. Problem Statement

1 The problem statement (in paragraphs or summary in bullet points).

• 5. Problem Identification /Literature

Review 1-2 The Problem Identification /Literature Review (in paragraphs or bullet points).

• 6. Problem Definition

1 The problem definition (in paragraphs or bullet points).

• 7. Objectives

1-2 The objectives (in bullet points).

• 8. Mission Statement

1-2 The mission statement (in table format).

• 9. Customer Needs Identification

1-2

• Identify your customer (Primary Market).
• How will you gather information to identify customer needs when you will

implement the project?

• 10. Associated Standards and Target

Specifications 1-2

• What Electrical Engineering, Safety, Regulatory, Environmental

Standards did you consider for your project?

• How did you transform customer needs into target specifications?
• 11. Design Concepts Generation

2-3

• What are your alternative concepts or ideas? List them in the table format.
• How did your team generate these ideas or concepts?
• Block diagrams of the concepts to explain each concept.
• 12. Design Concepts Selection

2-3

• What are the Pre-Specified Selection Criteria?
• Show Screening and Scoring Decision Matrices?
• What assumptions and realistic constraints did your team consider?
• 13. Conclusion

1 You have to conclude about what you have presented.

• 14. References

1

• References must be in the known format (see this file).
• To generate the references automatically, see the Citation file.
• Selective references only (the full list should be in the report).
• The references [1] & [2] should be the following two references (in the

presentation and in the report): [1] K. T. Ulrich and S. D. Eppinger, Product Design and Development. Boston: McGraw-Hill, 2000. [2] H. S. Fogler and S. E. LeBlanc, Strategies For Creative Problem Solving. NJ: Prentice Hall, 2008.

• You must have at least four other references in total. Here, in this

presentation, at least two more references in addition to [1] and [2] above should be listed.

• 15. THANK YOU & ANY

QUESTIONS? 1 This is to indicate the end of your presentation, and open the door for audience questions.